Follow

nLight Installation: Is There Any Order In Routing CAT5e Cable Between nLight Devices In A Single Control Zone?

The only concern in routing CAT5e cable in an nLight control zone is how many devices are providing bus power and how many devices are consuming bus power.  Best practice is to place bus power producing devices (nPP16, nEPP5 D, nIO LED, nPS80) equally between bus power consuming devices. 

A low bus power situation will show as a continuous rapid-flash, 3 blink, on the device LEDs.

 

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

Powered by Zendesk