Follow

Photocells Modes: What Is Photo Cell Mode (Function11) On Standard Sensors?

NOTE:  Photo Cell Mode, Function 11 requires the long method of programming.

Photo cell mode determines if the lights will turn off or remain on during occupancy once the photocell foot-candle Set Point has been exceeded.

1) Full on/off Ctrl (default):  Lights will turn off based upon light levels, even though the room is occupied.

2) Inhibit Only Ctrl:  In this mode, when the occupancy sensor is first triggered as "occupied", if the photocell set-point has been satisfied, the lights will not turn on.  If the photocell set-point has not been satisfied, the lights will turn on and the sensor will keep the lights on until the room becomes un-occupied (via the Occupancy Time Delay). 

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

Powered by Zendesk