Follow

Link-2-PC-Ethernet & Meta Server Network Configuration Requirements

*these steps are for the network configuration requirements
*to configure the lantronix device, refer to the attached lantronix documentation (How to Configure Xpoft.pdf)

Local Site Access
1. An assigned IP address to the lantronix device
  • Option 1 - Static IP address
    The lantronix device should be set to "static mode"
  • Option 2 - Dynamic IP address (through DHCP Server)
    The lantronix device should be set to "DHCP mode," and the DHCP server set to provide the lantronix device with the same IP address based on it's MAC address
2. Open port 10001 and allow for TCP & UDP Packets on both incoming and outgoing communications (note: for multiple devices, one port # per device is required. ex: 10002 for the second device all the way to 10010, etc.)

3. To allow access to the lantronix device configuration, open port 80 (Html) & port 9999 (telnet)

4. The computer that will be accessing the LC&D system should be under the same subnet & network with the lantronix device. Otherwise, VLANs should be configured properly to allow communication.

5. Windows XP 64-Bit, Windows Vista (x32 & x64), & Windows 7 (x32 & x64) are not yet supported. 

To Allow LC&D to access the system remotely via the internet
1. Port Forwarding or NAT translations may be used

2. Open port 10001 and allow for TCP & UDP Packets on both incoming and outgoing communications (note: for multiple devices, one port # per device is required. ex: 10002 for the second device all the way to 10010, etc.)

3. To allow access to the lantronix device configuration, open port 80 (Html) & port 9999 (telnet).

4. For security, only allow incoming communications from LC&D.

5. LC&D's public IP address to be provided upon request.

6. The lantronix device's Assigned IP address should be provided to LC&D, or the site's public IP address (if port forwarding was used). 

7. Windows XP 64-Bit, Windows Vista (x32 & x64), & Windows 7 (x32 & x64) are not yet supported.

 

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

Powered by Zendesk