Follow

How do I check for communication between Intelligent Junction Boxes and the Light Energy Manager

First, press status, IJB communication, and if at least one of the IJB's are communication with the LEM, it will show"online". 
If it does not show "online" there are not communicating IJB's and you will need to troubleshoot the wiring. 
If that shows online, you can check for individual IJB communication by pressing " advanced setup",  highlight "configuration groups"
highlight the group in question press "enter"  press "override", set the level at 100% and then press "set". 
At that point, any IJB for that group that is communicating with the LEM should go to 100%. If one does not, you must check for wiring connectivity.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

Powered by Zendesk