Follow

How do I make an occupancy sensor work in a manual on/auto off fashion with an SYPM 8L?

You can do it 2 ways:

With config, set the switch type to maintained, in groups, set the level to 45, in relays and 0-10 v ballasts, make sure the level is anything above the level set in groups, should be 50.

With the keypad, set the level for the group to 45 and then set the level in outputs to 50.


Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

Powered by Zendesk